返回首页

宁夏银川电动伸缩门匠心厂

本站导航

新闻动态

当前位置:网站首页 > 新闻动态 > 详细信息
温热型饮水机
添加时间:2019/2/23 13:33:19     浏览次数:
温热型饮水机使用时,按下加热开关,电源为“保温”指示灯提供电源,作通电指示。同时,电源分成两路:一路构成加热回路,使电热管通电加热升温;另一路为“加热”指示灯提供电压作加热指示。当热罐内的水被加热到设定的温度时,温控器触点断开,切断加热及加热指示回路电源,“加热”指示灯熄灭,电热管停止加热。
When the warm water dispenser is in use, press the heating switch, and the power supply provides the power supply for the "heat preservation" indicator lamp as the power-on indication. At the same time, the power supply is divided into two ways: one is to form a heating circuit to make the heating pipe heated by electricity; the other is to provide a voltage for the "heating" indicator lamp as a heating indication. When the water in the hot pot is heated to the set temperature, the contacts of the thermostat are disconnected, the power supply of the heating and heating indicator circuit is cut off, the "heating" indicator is extinguished, and the heating pipe is stopped.
当水温下降到设定温度时,温控器触点接通电源回路,电热管重新发热,如此周而复始地使水温保持在85-95℃之间。
When the water temperature drops to a set temperature, the contacts of the thermostat are connected to the power supply circuit, and the electric heat pipe is re-heated, thus keeping the water temperature between 85 and 95 degrees centigrade repeatedly.
温热饮水机电路中为双重保护元件,当饮水机超温或发生短路故障时,超温保险器自动熔或手动复位温控器自动断开加热回路电源,起到保护作用。超温保险器是一次性热保护元件,不可复位,等排除故障后按原型号规格更换新的超温保险器,再用手按手动复位温控器的复位按钮,触点闭合便可重新工作。
The circuit of warm and hot water dispenser is a double protective element. When the water dispenser is over-heated or short-circuit fault occurs, the over-temperature protector automatically fuses or jinghuaqi.37ix.com.cnzhuzaoj.37ix.com.cn zhuzaopj.37ix.com.cnfeiqiql.37ix.com.cnfeiqijh.37ix.com.cnfeiqizl.37ix.com.cnmanually resets the thermostat to automatically disconnect the power supply of heating circuit, thus playing a protective role. Overtemperature protector is a disposable thermal protection element, which can not be reset. After troubleshooting, the new overtemperature protector can be replaced according to the prototype size. Then the reset button of the manual reset thermostat can be pressed by hand, and the contacts can be closed to work again.
上一页  净水桶  
下一页  取水桶清洗方法
  • 关于我们
  • 新闻动态
  • 案例展示
  • 网上订单
  • 联系我们
  • 产品分类1
  • 产品分类2
  • 产品分类3

Copyright © 技术支持:遨游网络

  • 联系我们
  • 网上订单
  • 工程案例
  • 本站导航

搜索

  • 关于我们
  • 新闻动态
  • 案例展示
  • 网上订单
  • 联系我们
  • 产品分类1
  • 产品分类2
  • 产品分类3