| 温热型饮水机的工作原理和使用技巧 |
| 添加时间：2017/6/14 15:09:32 浏览次数： |
| 温热型饮水机使用时，按下加热开关，电源为“保温”指示灯提供电源，作通电指示。同时，电源分成两路：一路构成加热回路，使电热管通电加热升温;另一路为“加热”指示灯提供电压作加热指示。当热罐内的水被加热到设定的温度时，温控器触点断开，切断加热及加热指示回路电源，“加热”指示灯熄灭，电热管停止加热。 When the thermotype water fountain is used, press the heating switch, the power supply is the "insulated" indicator lamp to supply the power supply, as the electrical indicator. At the same time, the power supply is divided into two directions: the heating circuit is made up, and the electric heating tube is heated up. The other way is to supply voltage to the heating indicator. When the hot water tank is heated to the temperature set, thermostat off contact, to cut off the heating and heating indicating circuit power, "heat" light is put out, stop heating electric heating tube. 水温下降到设定温度时，温控器触点接通电源回路，电热管重新发热，如此周而复始地使水温保持在85-95℃之间。 Water temperature drop to set temperature, the thermostat contacts connected power supply circuit, electric heat pipe to heat, so the cycle to keep the water temperature is between 85-95 ℃. 温热饮水机电路中为双重保护元件，当饮水机超温或发生短路故障时，超温保险器自动熔 或手动复位温控器自动断开加热回路电源，起到保护作用。超温保险器是一次性热保护元件，不可复位，等排除故障后按原型号规格更换新的超温保险器，再用手按手动复位温控器的复位按钮，触点闭合便可重新工作。 Tepid water dispensers for double protection circuit element, or short circuit fault occurs when water dispenser overtemperature, overtemperature fuse fuse or manual reset automatically thermostat automatic turnoff heating power circuit, protection. Overtemperature fuse is one-time thermal protection components, reset, etc according to replace the original specifications after troubleshooting overtemperature fuse, reoccupy hand according to the manual reset button reset thermostats, contact closure can be back to work. |
| 上一页 饮水机的致菌十大原因 |
| 下一页 饮水机桶为什么上面没口 |
Copyright © 技术支持：遨游网络